Asus h170 pro gaming You just have to install Clover on your main SSD, copypaste the USB Kext folder and config.The benefits are basically zero, It could bring only some downside.On the Apple docs it's written that it uses ECC built in Apple Firmwares, but our SSDs don't have Apple Firmwares.
Asus h170 pro gaming All my six 16x risers worked but two of the 1x adapters were faulty.Will that be enough in the long term?Hit Delete because you don't want to boot an OS just yet.Fix a riser to the graphics card and plug in the power cables.
Asus h170 pro gaming As the procedure I used was for some parts following his guide, I'll copy paste some parts, hopefully it's fine for him, otherwise I'll reformulate.If your computer POST's then switch off (and turn off the power supply switch), unplug the 1x adapter from the USB cable and keep it in the "good" pile.Do this for your remaining graphics cards and finally you should have a nice mining rig set up just like mine.I've just spent a month trying to get more than 3 graphics cards to run on my Asus Z170 Pro Gaming motherboard and finally succeeded yesterday after much fault finding.
Every modification is on the EFI partition, so your main partition is untouched , is the same as a real mac.SO I am not sure about how our SSD fix the errors that naturally happens on flash drives.Edition Monitor: Dell UP2715K 5K monitor dual stream (it's not perfect for hackintosh, but it works) Keyboard: Logitech G910 Orion Spectrum, fully works in BIOS and Clover Mouse: Logitech g502 - fully works in BIOS and Clover, and with the Logitech Gaming Software I have some macros for Expose, switching from desks, and everything as a Magic Mouse (and more, like DPI switching) 2.
How to set up a 6 GPU mining rig on an Asus Z170 Pro Gaming motherboard.Download the latest motherboard BIOS to a USB stick and install.Obviously maybe at some point you'll need to update a kext or a patche, but the troubleshooting is easier as everything is in a few folders.If your PSU doesn't have a switch then unplug from the wall.Switch off and install one card at a time in your Operating System - install a card, boot to your OS, install the drivers, mine something easy like Ethereum for a few minutes.This has some benefits, the main is that everything is update-persistant, as the update only touch the main partition and not the EFI.
I used the latest of everyone, as I am writing.If I had known these 2 steps a month ago, I would have more hair.My main concern is not that it will not work.Turn on the power and see if your computer POST's.This will enable ALL PCI-E risers to work on the motherboard.